Quick installation Guide
1.
Please use the provided screws to secure
the handles to the HDDs.
2.
Press down the lock to open the cover.
3.
Slide 2 HDDs into the chassis and make sure they are securely
installed in order from left to right.
Make sure the HDD1 is securely installed first at all times.
Otherwise the PC may not recognize the device.
4.
Close and secure the covers.
5.
Plug in power adapter and USB cable.
Blue / Active
Blue / Active
7.
There are 4 mode options for HUR3-SU3S3, Single, JBOD (Spanning) , RAID 0 and RAID 1.
The enclosure is not default to any of the above.
So If you just put hard drives in without setting a mode to use,
the enclosure will just turn off after a few seconds of turning it ON.
The
confirmation button
is hidden in the back, so please find it first before you start.
The setup procedures are as follows,
Make sure the enclosure is connected to a computer that is ON.
Power on the enclosure and press and hold MODE button on the front
until mode option LED flashes. Press it again to select the RAID mode you want
then press the Confirmation button on the back panel until the device shuts down.
Power on the device again and the RAID mode set-up is completed.
Now you just need to partition and format the drives.
Note: User have to make sure the host e-SATA port
supports port-multiplier.
6.
Mak sure the PC is ON and ready to go, then power on the device.
Blue
Defaut Setting is at ”AUTO” mode.
8.
FAN mode setup, users need to press the "FAN" button to change mode.
Blue / Active
Blue / Active
Orange / Single Mode
Blue
1
2
PC
Front view
Back view
A
B
C
