TV IR Code Table:
Note: Above code is applicable for most popular TV band on market, later TV or
band code may not be included; Code may result in improper function for some
keys on the IR portion; change the next code until they are fully function.
Trouble Shooting
Keyboard
• PC power button not working – You need to press and hold 2 seconds to shut
down PC; intention is to avoid accidently shut down; This RF KB button cannot
turn on the system due to its PC nature
• MCE/HOME; Back Key; Media Playing and MCE FN Hotkey not working on other
front end (software/application) – These keys are designed for Microsoft Media
Center Edition and Media Player. They are hot-coded and cannot be programmed
for third party application
• ZOOM in and out key not working – These two keys are for Internet (Web) Browsing
ONLY; not for Operating System and other applications. And for Internet Explorer,
it is compactable for Microsoft Internet Explorer 7.0 and or above. Other browser
is not tested and considered not support. Try search the below KB Hot keys to see
if they will work for your application or web browser:
. ZOOM In = CTRL + +(plus)
. ZOOM Out = CTRL + 0
• The E-Pointer is so slow; and or it is so fast that I don’t have good control experience
on it – Open Control Panel and Click on Mouse to adjust the Pointer Speed in Mouse
to the best fit speed
• My KB stops functioning suddenly – Check battery and replace with new to test.
Battery life may go out during unattended time
TV Universal IR Remote
• In auto search mode, IR keys not working – Be patient, this process may take 4-
8 minutes to search the code depend on the TV brand and model
• In manual code entry, my remote not working – Repeat the steps by using the
next code until the remote fully function. Be Patient
• How can I change TV Input – Press the INPUT key again, and it will switch to the
next input. In small percentage of the TV, you may need to use the TV up/down/
ok key to switch input, but the chance will be minimum
How do I use the other TV keys – Due to the compact design, we only select the
HTPC most used buttons: Mute/Vol+/Vol-/Input/Power & #s (back)
ID (CONNECT) Setting:
The frequency is pre-set in the factory, there is no need set ID setting unless you
believe there is a serious interference with other RF device that is nearby.
Note: For optimal performance, please place the USB dongle receiver 20cm away
form the other RF interference devices such as Computer monitors and speakers.
To reset the product ID (CONNECT), follow these steps;
(1) Remove the receiver from the PC; and re-plug it in
(2) Press the ID Connect key on the back of the KB for 30 seconds
(3) ID (CONNECT) setup process is completed
(4) If the above steps do not complete the band change, please follow these steps
to clear ID (CONNECT):
1 Remove the battery from the keyboard
2 Press and hold the button on the frequency
3 Insert the batteries into the keyboard
4 Release of the band button, complete the ID (CONNECT) cleared
5
6
