9
Inverting of axis
By using the jumpers at the inputs, each driver can be inverted easily. This can be done during
scanning also. Just pull out the jumpers and put them in at 90° rotated.
Heatsinking
The MicroAmps are relatively insensitive to heat, since the power stage contains a overheat
shutdown. To assure full function, the MicroAmp should be used with the attached heatsink.
If you want to save space, remove the heatsink and mount the amp on a metal housing, to
remove the heat from the power stage. The temperature at the heatsink should be below 70°C
(170°F)
In / Outputs
On the 8pin connector, all necessary in and outputs are available. Here is the power supply
connected, the symmetric inputs and also the feedback outputs for the CAT-SAFE board. We
recommend a ground free operation between computer and drivers.
ATTENTION! Do not use FEEDBACK as inputs. This will instantly destroy your
galvanometers!
