Discover the Power of
5
© 2013, Media5 Corporation
Document Revision 14
Mediatrix C7 Series
Installation – SIP
Warning:
In the following installation procedures, do not disconnect the
Mediatrix C7 Series while the LEDs are flashing.
Thank you for choosing the Mediatrix C7 Series. This Quick Start will help you to properly connect all of the cables to the Mediatrix C7 Series and access
its web interface.
Please read the
Mediatrix C7 Series Hardware Installation Guide
for detailed installation information and the
Mediatrix C7 Series
Software Configuration Guide
for in-depth configuration information.
Step 1
Connecting Cables
The following describes how to connect the various cables to the Mediatrix C7 Series. Since there are many flavours of the Mediatrix C7 Series unit, some
of the information provided may not apply to your particular Mediatrix C7 Series unit model.
Before you begin, make sure that you have a working network connection. Then follow these steps to install the Mediatrix C7
Series.
1.
Before you begin, be sure that the Mediatrix C7 Series is
powered off.
2.
Connect the power adaptor to the Mediatrix C7 Series.
3.
Models with FXS ports:
Connect analog telephones or fax
machines into the
FXS
connectors.
Use a standard telecommunication cord with a minimum of
26 AWG wire size.
4.
Models with FXO ports
: Connect a SCN line into the
FXO
Ports.
Use a standard telecommunication cord with a minimum of 26 AWG wire size.
5.
Connect a 10/100 BaseT Ethernet RJ-45 cable into the
ETH1
connector of the Mediatrix C7 Series; connect the other end to a compatible
Ethernet interface that supplies TCP/IP network access (e.g., router, switch, hub or computer).
You can either use a crossover or straight Ethernet cable because it performs automatic MDI / MDIX detection.
Model
Interfaces
C710
4 FXS
C711
8 FXS
C730
4 FXO
C733
8 FXO
C731
4 FXS + 8 FXO
Note:
The FXS and FXO ports may differ location depending on the model you have.
1
2
3
4
1
2
3
4
FXO
FXS
ETH2
ETH1
USB
Power
Reset /
Default
12V
2.5A
2
3
4
6
5
