Media5 Mediatrix 4104, Справочное руководство

Страница: 31 / 466

Choosing a Suitable Installation Site Reference Manual (SIP Version)
Mediatrix 4104 9
Wall-Mounting
The Mediatrix 4104 has two screw holes on its bottom surface, allowing a single unit to be wall-mounted.

To wall-mount the Mediatrix 4104:
1. Disconnect all of the cables from the Mediatrix 4104 before mounting.
2. Ensure that the wall you are using is smooth, flat, dry and sturdy. Attach a piece of plywood,
approximately 250 mm x 200 mm x 12 mm (10 inches x 8 inches x 0.5 inches) securely to the wall,
if necessary.
3. Position the Mediatrix 4104 against the wall (or plywood) as illustrated in Figure 4 .
Figure 4: Bottom View - Wall Mounting Screw Holes
You can position the Mediatrix 4104 any way you want.
4. Mark the position of the screw holes on the wall. Drill the two holes and install two screws.
5. Place the screw holes of the Mediatrix 4104 over the screws installed in the previous step.
6. Proceed to “Hardware Connection” on page 10 .
Free Standing Unit
When installing the Mediatrix 4104 on a desk or table, it should be located at least 20 cm from your monitor,
computer casing or other peripherals, including speakers. Never put books or paper on the Mediatrix 4104.
You can stack units on top of each other provided that you apply the Bumpon
TM
authoadhesive protective
products to the bottom of each Mediatrix 4104. These will stabilize the Mediatrix 4104 and offer skidding
resistance. If you are mixing a variety of hub units, position the smaller units at the top.
Condensation
When bringing the unit into a warm environment from the cold, condensation may result that might be harmful
to the unit. If this occurs, allow the unit to acclimatize for an hour before powering it on.
Cleaning
To clean the Mediatrix 4104, wipe with a soft dry cloth. Do not use volatile liquids such as benzine and thinner
that are harmful to the unit casing.
For resistant markings, wet a cloth with a mild detergent, wring well and then wipe off. Use a dry cloth to dry
the surface.
Front
Rear
Screw holes