Media5 Mediatrix 3308, Руководство по установке оборудования

Страница: 33 / 66

RESET/DEFAULT Button Hardware Installation Guide
Mediatrix 3300 – Analog Gateway 23
At Start-Time
You can use the RESET/DEFAULT button at start-time – you power the unit off, and then depress the button
until the LEDs stop blinking and remain ON. This applies the “Factory Reset” procedure (see “Factory Reset”
on page 24 ). This feature reverts the Mediatrix 3300 back to its default factory settings.
Partial Reset
The Partial reset provides a way to contact the Mediatrix 3300 in a known and static state while keeping most
of the configuration unchanged.
Following a partial reset, the Mediatrix 3300 management interface is set to the Rescue interface. The default
address for this interface is 192.168.0.1/24 and has its corresponding link-local IPv6 available and printed on
the sticker under the Mediatrix 3300. Any existing network interface that conflicts with the Rescue interface
address is disabled.
You can contact the Mediatrix 3300 at this address to access its configuration parameters. It is not advised to
access the unit on a regular basis through the
Rescue network interface. You should reconfigure the unit’s
network interfaces as soon as possible in order to access it through another interface. See “After a Partial
Reset” on page 23 for more details.
In a partial reset, the following services and parameters are also affected:

AAA service: User(s) from profile are restored with their factory password.

SNMP service: Resets the enableSnmpV1 , enableSnmpV2 , enableSnmpV3 and snmpPort
values to their default values.

WEB service: Resets the serverPort to its default value.

To trigger the Partial Reset:
1. Insert a small, unbent paper clip into the RESET/DEFAULT hole located at the rear of the Mediatrix
3300. While pressing the RESET/DEFAULT button, restart the unit.
Do not depress before all the LEDs start blinking (between 7-11 seconds).
2. Release the paper clip.
After a Partial Reset
Following a partial reset, you should:
1. Create or activate network interfaces as described in the Software Configuration Guide , Chapter
Interface Parameters , Section Interfaces Configuration . Do not disable the Rescue interface!
2. Change the Mediatrix 3300 system management network interface to something other than Rescue
as described in the
Software Configuration Guide , Chapter Miscellaneous – Management Interface ,
Section Management Interface Configuration .
Note that you must be able to contact the interface you select in order to continue with the following
steps.
12 to 16 seconds Restarts the
Mediatrix 3300 in
Factory Reset Deletes the persistent
configuration, creates a new
configuration file with the default
factory values, and then restarts
the unit. All LEDs
• steady ON
17 seconds and
more No action is taken The RESET/DEFAULT Button
Pressed event is ignored N/A
Table 13: RESET/DEFAULT Button Interaction (Continued)
RESET/
DEFAULT Button
Pressed for:
Action Comments LEDs Pattern