MED ASSOCIATES INC.
VIDEO ZERO MAZE
- 2 -
ASSEMBLY INSTRUCTIONS
The Video Zero Maze (VZM) has been separated into basic components for shipping
purposes. Begin by unpacking all components of the maze. Locate the maze base
and
situate it in the location where testing will be performed. Be sure that the area is evenly
lit and the maze base is centered on the blue plastic mat. The mat should be oriented so
that it protrudes from under the open sections of the maze.
Camera Mount and Lights
The camera mount and lights must be placed on the crossbeam prior to assembling the
maze. Locate the crossbeam, camera mounting bracket, lights, and firewire camera,
shown in Figure 1.
Figure 1 - Crossbeam, Lights, Camera Brackets and Camera
1. Notice that the crossbeam has a cable clamp mounted on it. This is the top of the
crossbeam.
2. Slide the camera bracket onto the crossbeam so that hole in the top center of the
crossbeam is aligned with the hole in the top of the camera bracket. Fix the camera
bracket in place using the included thumbscrew.
3. Notice that one of the lights has a cable clamp mounted on the top of it, and the
other does not. Slide the light without the clamp onto the end of the crossbeam that
does not have a clamp on it, as shown in Figure 2. Slide the light onto the
crossbeam until it hits the camera bracket.
Figure 2 - Camera Bracket and Lights Mounted on Crossbeam
4. Slide the other light onto the other end of the crossbeam.
5. Orient the lights as desired on the crossbeam and fix in place using the thumbscrews.
6. Install the Firewire camera into the camera bracket and fix in place using the
included thumbscrew, as shown in Figure 3.
DOC-014 Rev 1.3 Copyright © 2013
MEd Associates. Inc