Meccanica Fadini Elpro 33 exp, Схема подключения

Страница: 2 / 4

E lpro 33
exp
DESCRIPTION OF THE FUNCTIONS OF THE CONTROL PANEL FOR SWINGING GATES
CLR ENT
"A" "B"
DISPLAY
All the electrical connections are to be made as per the instructions and diagrams that follow. Supply the terminals 24-25 with
230 - 50 Hz single-phase voltage. The "red led" No. 1 goes on, this is the sign that the PC board is properly supplied. The word
"BLOCCO" (Stop) is running from right to left in the display.
PARAMETERS AND MODES. SETTING PROCEDURE
Through the dispaly and by the programming buttons it is possible to access to and change all the functions of Elpro 33 exp.
The programs are devided into parameters (ie. variations of the times ) and modes (ie. the functions).)
PROGRAMMING BUTTONS
CLR =
TO CLEAR OR VISUALIZE THE PARAMETERS OR THE MODES
(WHEN THE DISPLAY FLASHES)
=
TO INCREASE VALUES OF PARAMETERS OR CHANGE MODES
"A"
=
TO DECREASE VALUES OF PARAMETERS OR CHANGE MODES
"B"
ENT =
TO CHANGE (WHEN THE DISPLAY FLASHES) AND THEN TO
CONFIRM ALL THE PARAMETERS AND MODES
= READING SCREEN =
To gain access to the parameters and modes press the button , the display visualizes the word "CODE" and immediately afterwards
“0” ie. one of the two possible options of the program:
- “0” program is stopped
- “1” access to program allowed, ie. to parameters and modes
To change from “0” to “1”, press the button “ENT” value “0” flashes. Change is allowed.
press the button value “1” is displayed (flashing) .
press the button “ENT” the value stops flashing. Change is confirmed.
press the button
the first parameter “PR1A” is displayed.
Go on pressing the button and the following list of parameters and
modes appears in a sequence:
MODES: MOD9
MOD8
MOD7
MOD6
MOD5
MOD4
MOD3
MOD2
MOD1
PARAMETERS: PR10
PR9C
PR9A
PR8
PR7
PR6
PR5
PR4
PR3
PR2
PR1B
PR1A
ABBREVIATIONS TO APPEAR
ON THE SCREEN
(DISPLAY)
YOU CAN GO DOWN THE
MENUE BY PRESSING
THE BUTTON:
FROM PR1A to MOD9
"A"
"B"
THIS DIRECTION UP BY
PRESSING THE BUTON:
This section explains how to change the parameters and modes:
select the desired option and wait three seconds for the previously set value to appear.
press the button
“ENT” the value starts flashing, changing is allowed.
press either or to increase or decrease the previous value.
press the button “ENT” the value stops flashing, change is confirmed.
You can go back to the original menue options
"A" "B"
To exit the program:
press the button until “CODE” and soon afterwards “1” are displayed.
press the button “ENT” value“1” starts flashing, ie. changing is allowed.
press the buton value “0” is displayed (flashing).
press the button “ENT” the value stops flashing, change is confirmed.
press the button gate status ie. operations to perform are diplayed in words
(see the section "gate status on display")
- The button "CLR" allows to exit a parameter or mode without changing its value and, in case a value is displayed, to see which
parameter or mode has been previously selected
.
"B"
"B"
"B"