The machine is normally delivered packed
into a carton with or without accessories that
may be packed into other cartons due to their
dimensions.
To prepare the machine do in this way:
Helped by right instruments, take the machine
away from the carton ; put the handlebar in
the position you want and fix it with its
handgriff.
The engine is already full with oil. On the
contrary a yellow ticket tell you that the
engine is
without oil
.
If engine is equipped with an air filter in oil
bath, fill its small box with oil SAE 20-40 as
far as the level shown on it. Due to the
transport, the filter is delivered without oil.
Machine used as walking-tractor
- put the handlebar opposite to the engine;
- lubricate or grease the engagement coupling
(male part) of the tiller;
- take away the fixing pin placed on the body-
machine.
- insert the tiller coupling inside the body-
machine, keeping the axle of the P.T.O shaft with
the same inclination of the tiller shaft. Insert it
completely putting the lock pin in the lower part
and fixing it by its cotter pin.
T h e ma c h i n e ma y b e e q u i p p ed w i t h “ t r a c t o r ”
t i r ed wh e e l s o r c ag e wh e e l s .
If you turn the handlebar support or take away the
wheels, pay attention to the right direction that they
must have ,as shown in the side picture.
Make a good running-in of the engine and of the
machine (at least for 10 hours don’t use more than
70% of the engine power).
Always use the clutch before operating any levers or
rods.
Don’t keep too much the clutch disengaged.
Never use much strength when you fit levers and
rods as it is possible to damage the machine. If it is
difficult the engagement of levers and rods, move
the machine with wheels engaged or make a light
pressure on those levers or rods hard to be engaged.
Keep the handlebar joint clean and oiled.
10 – WORK STARTING
Machine used as motormower
- adjust the handlebar in a way to have them
above the engine.
- fit the cutting bar to its mower set by using the
4 available screws.
- lubricate with oil or better with grease the
engagement coupling (male) of the mowing bar ;
- take away the fixing pin placed on the body-
machine.
- insert the coupling of the mowing set inside the
body-machine, keeping the axle of the P.T.O
shaft with the same inclination of the mowing
bar shaft. Insert it completely putting the lock
pin in the lower part and fixing it by its cotter
pin.
DURING THIS ACTION KEEP ALWAYS
ON THE BLADE ITS GUARD.
Never use much strength when you fit the
accessories as it is possible to damage the
centring ring and the engagement manifold.
Never press the engine; when you see some
smoke coming out from the exhaust pipe ,
the engine is under stress.
Never work for long periods at maximum
power, especially in hot periods.
Periodically check the pressure of tyres (1,3
Atm ).
Never leave the machine under the rain.
11 – RULES FOR A GOOD WORKING OF THE MACHINE
- 7 -
