Instruction Manual
ATLAS-300 Series
- 3 -
Charging Advice and Battery Care
Charging Advice:
•
If the charger must be disconnected from the battery during the charging process, please FIRST disconnect the charger from the mains supply.
The continuation of the charging process is equal to a new charging cycle; all relevant points of the Operating Instructions have to be considered.
•
To lengthen the lifetime of the battery, please do not stop the charging process before the battery is fully charged. The charger will automatically
stop when the charging process is completed.
Battery Care:
•
Never expose the battery to high temperatures, as this causes permanent battery capacity loss.
•
Never deep-discharge or overcharge the battery, cells can be damaged irreversibly.
•
If possible, always disconnect the battery from the load when being stored over long period of time.
•
Store battery in a dry and cool place at about 40-60% of its rated capacity.
General Errors Description
Solutions
No LED lighting or blinking after connecting to the mains
•
Check if the charger is connected to mains supply properly
•
Check if there are any problems with the mains supply
Red Mains-LED is on, charger is connected to the battery,
but the charging process seems not working
•
Check the connection to battery
•
Check if the battery is damaged or has been deeply discharged
Error-LED blinking (N x blinking / 2 secs pause)
•
Please refer to the table below for LED Blinking Signals
LED Blinking Signals
Blinking Signal (continuous looping)
Error Description
1 x
Battery damaged
2 x
Battery voltage is too high or wrong battery connection
5 x
Charger temperature is too high during the charging process
8 x
Short-circuited
Advice for Disposal
It is prohibited to dispose the charger with household or residual waste removal (WEEE-Richtlinie 2012/19/EU und
EAG-VO). The charger must be disposed at designated disposal points. For the protection of our environment, please
check at your communal adminstrative agency of your nearest disposal point.
The
charger
conforms to
the
RoHS-directive
EU 2015/863,
for
the
restriction
of
the
use
of
certain
hazardous substances in electrical and electronic equipment.
Disclaimer of Warranty
The warranty period (see our General Terms and Conditions) starts with the charger being dispatched by the manufacturer. The Company accepts
liability by guaranteeing to working hours and spare parts only.
For damages caused by non-observance of the operating instructions, inappropriate start up or handling as well as dismantling, reconstructions or
modifications of the charger, the warranty claim expires and the Company assumes no liability for consequential damages to any properties or persons
in connection with or arising from the purchase and use of the charger.
We reserves the rights to configure the charger as per actual needs and the manual may not reflect the most updated conditions of the product at all
times. Please contact us should you need any technological support.
Errors and Troubleshooting
MEC-Energijski sistemi,d.o.o.
Cesta na Okroglo 5, 4204 Naklo, Slovenia/Europe
Tel: +386 (0) 59 028 800
Email: [email protected]
www.mec-europe.com
