Page 21
69 Seres - Operator’s Manual
February 2019
Operating Instructions
Do Not Operate Unless:
You learn and practice the principles of safe machine operation contained in this operator’s
manual.
Avoid hazardous situations.
Always perform a pre-operation inspection.
Inspect the workplace.
Always perform function tests prior to use.
Only use the machine as it was intended�����
Fundamentals
This machine is a self-propelled hydraulic lift equipped with a work platform on the scissor
mechanism. Vibrations emitted by these machines are not hazardous to an operator in the work
platform. The machine can be used to position personnel with their tools and supplies at position
above ground level and can be used to reach work areas located above and over machinery or
equipment.
The Operating Instructions section provides instructions for each aspect of machine operation.
It is the operator’s responsibility to follow all the safety rules and instructions in the operator’s manual.
Using the machine for anything other than lifting personnel, along with their tools and materials, to an
aerial work site is unsafe and dangerous.
Only trained and authorized personnel should be permitted to operate a machine. If more than one
operator is expected to use a machine at different times in the same work shift, they must all be
qualified operators and are all expected to follow all safety rules and instructions in the operator’s
manual. That means every new operator should perform a pre-operation inspection, function tests,
and a workplace inspection before using the machine.
Emergency Stop
Push in the red Emergency Stop button to the off position at the ground controls or the platform
controls to stop all machine functions and turn the engine off.
Repair any function that operates when either red Emergency Stop button is pushed in.
Emergency Lowering
Pull the emergency lowering knob.
Starting the Engine
At the ground controls, turn the key switch to the desired position.
Be sure both ground and platform control red Emergency Stop buttons are in the on position.
Press the glow plug button for 5 seconds.
Press the engine start button.
If the engine fails to start after 15 seconds of cranking, determine the cause and repair any
malfunction. Wait 60 seconds before trying to start again.
•
1.
2.
3.
4.
5�����
1.
1.
2.
3.
4.
Operating Instructions
Secton 7 - Operatng Instructons
