Mec 300E ATA, Руководство пользователя

Страница: 8 / 18

Page 8 Version 2
CENTERING THE FIELD
Step 10
– Set the bolt in the center of the rotation gear box shaft as shown in Photo #1 below. To
center the field, fire a clay and see if the clay comes out of the center of the trap house and travels
straight away down the center of the field.
Step 11
– Next, adjust the turnbuckle if the clay is not traveling straight away down the center of the
field. Simply loosen the nuts on the turnbuckle and either push or pull the machine to get the trap to
fire the clay on center.
RETIGHTEN THE NUTS ON THE TURNBUCKLE TO HOLD THE
CORRECT ADJUSTMENT!!!
Step 12
– Once centering the clay is achieved, remove the 3/8” allen bolt from the center of the shaft
(Photo #1), and place the jam nut under the clamp block as shown below in Photos #2, #3 and #4.
Step 13
– Tighten the bolt in the center of the clamp block slot. You can now test the angle that the
machine will throw the clay.
Step 14
– To open up the flight angle of the clay, loosen the 3/8” allen bolt and slide it out on the slot
of the clamp block. Retighten the bolt securely and test fire. Sliding the bolt in on the slot will reduce
the angle flight of the clay.
1. 2.
ADJUST THE
TURNBUCKLE
HERE TO
CENTER THE
FIELD.