Page 22
92555
June 1, 2012
Crossover Series
Crossover Series
Operating Instructions & Function Tests
Pothole Protection Bars
This machine is equipped with Pothole Protection Bars. These are
activated electronically, are hydraulically actuated and lock into place. A
limit switch confirms full deployment.
Pothole Protection Bars deploy when the platform reaches 20 ft (6 m)
height and drive is initiated.
Confirm proper operation of the Pothole Protection Bars during the
Pre-Start Inspection. DO NOT use this machine if the Pothole Protection
Bars do not function properly.
Outrigger Operation (optional)
Lower the outriggers only when the machine is on a firm surface. The
surface must be capable of supporting the maximum ground pressure per
wheel/outrigger (see Specifications).
The Outrigger Control Switch is located on the front face of the Upper
Control Box.
Check that all ground personnel are clear of the machine before deploying the outriggers.
Extend
Push and hold the Outrigger Control Switch DOWN to extend the outriggers.
• The outriggers will extend and level the machine. When the machine is level and
ready to operate, the outriggers will stop automatically.
• The Drive Enable Indicator Lamp will turn OFF, indicating that the outriggers are
extended and that machine drive function is disabled.
Retract
Push and hold the Outrigger Control Switch UP to retract the outriggers.
• The outriggers will retract.
• The Drive Enable Indicator Lamp will turn ON, indicating that the outriggers are
retracted and that machine drive function is enabled.
ART_
3
892
ART_3844
