MEC
– Energietechnik GmbH
INSTRUCTION MANUAL
161-150-430
Vers.: 30032010
Page 2 of 4
GLN: 9008390331330
2. General Information
This Acid Battery Charger was especially developed for the use
in strict alignment with the battery manufacturer’s
specifications. It is possible to construct an individual charge profile with up to 5 distinctive phases. Each phase,
in turn, may either be assigned current-, voltage- and / or time thresholds and "AmpHour counting", these being
the criteria for the change-over to the next phase, "Battery full" detection or auto restart.
The output of the charger is electronically protected against short circuit, reverse polarity connection and deeply
discharged batteries. Three coloured LEDs on the front panel are used as a charging and state of charge indica-
tor.
3. Special Features
Configurable charging technology with up to 5 phases
Self diagnostics at start-up
Highfrequent switching technology
LEDs to indicate operation and charging status
Wide range input 100-240V, 50-60Hz
Battery monitoring and charge history recording
Error conditions statistics recorded
External battery temperature sensing (optional)
Cooling with load-dependent fan
Overheat protection
Overload-, reverse polarity- and short circuit protection
Power de-rating at elevated environmental temp.
Spark suppression during battery connecting
4. Scope of delivery
1. Power cable (country-specific)
4. Green Full-LED
7. Temperature sensor connector
2. Charging cable with alligator clamps 5. Yellow Charging-LED
8. Mains connector
3. Red Power-LED
6. Error-LED
1
8
2
3
7
4
5
6
