Mean Green Products STALKER, Руководство пользователя, Страница: 31 / 48

Mower blade removal
Use a 9/16” wrench or socket to remove the 3/8” cap screw
holding the blade to the motor shaft from underneath. It may be
necessary to use a 1-1/4” channel lock pliers to keep the blade adapter from
turning while removing blade cap screw.
NOTE:
The blade adapter will come off when the blade cap
screw is removed. Touch-up sharpening can be done with a file.
Check the blades for balance following grinding. A
commercial balancing tool is available through most hardware
supply stores, or balancing can be done by placing the blade on
an inverted line punch or 1/2” bolt. Blade should not lean or tilt.
Spin the blade slowly, blade should not wobble. If blade is out
of balance, true it up before reinstalling.
Lay the blade on a flat surface and check for distortion. Replace any distorted blade.
Mower blade installation
Do not re-use spindle bolts which have stripped, worn or
undercut threads.
Make sure that the blade adapter is seated properly on the
blade motor shaft before tightening the blade cap screw. Use a 9/16”
socket with a torque wrench to re-attach the blade to the
motor shaft from underneath. It will be necessary to use a 1-1/4”
channel lock pliers to keep the blade adapter from turning. Torque cap
screws on motor shafts to 50 foot-pounds (67.8 Nm) when
reinstalling blades.
IMPORTANT:
The blade sail (curved part) must be pointing
upward toward the inside of the deck to ensure proper cutting.
IMPORTANT: When mounting blades, rotate them after
installation to ensure blade tips do not touch each other or sides
of the mower.
WARNING:
Failure to correctly torque the bolt may
result in the loss of the blade which can cause serious
injury.
WARNING: Mower blades are sharp and can cut.
Wear gloves and use extra caution when servicing
them.
ELECTRICAL SYSTEM
Electrical System Safety
Remove key, disconnect battery cables
by pulling inward on
RED battery quick disconnect
handle in battery box compartment and read owner’s manual
before adjusting or repairing unit.
Always remove key and disconnect battery cables
by pulling inward on
RED battery quick disconnect
handle in battery box compartment before working on this unit.
Always disconnect battery cables by pulling inward on
RED
battery quick disconnect handle in battery box compartment
when transporting unit.
Keep unit free of grass clippings, leaves and other debris.
DO NOT spray water to clean unit. Use only compressed
air. Wear adequate eye protection when cleaning the unit.
Always wear safety glasses and protective gear near batteries.
Use insulated tools.
Clean battery compartment, drive motor compartment,
mower deck, seat etc. of all dirt and debris. Do not spray
unit with water. Do not use, solvents, hard cleaners or
abrasives. Use only compressed air.
Avoid injury. With key in ON position mower blade can
24