11
TROUBLE SHOOTING
---------------------------------------------------------------------------------------------------------------------------------------
TROUBLE
CAUSE
SOLUTION
The display shows
‘00’ or
‘99’
There is a problem with the
circuit
Please contact Meaco
The fan does not oscillate
The MPCB needs resetting
Unplug the fan from the mains
for 40 minutes
Increased noise level
The fan blades are dirty
Clean the fan blades (see page
9)
The fan blades or fan motor is
loose
Tighten the locking cap (see
page 9)
There is a fault with the fan
motor
Please contact Meaco
The motor can be heard on
the lower fan speeds
As the fan is so quiet it is
expected to hear the motor on
the lower fan speeds. As the
fan speed increases, the noise
of the motor will reduce
This is not a fault and is normal
The fan does not start up
The fan is in standby mode
Press the power button again
The fan is making a clicking
noise
The fan needs lubricating
Run the fan on the highest fan
speed for 4 hours
The remote does not work
The battery needs replacing
Replace the battery (see page
10)
The remote is being used more
than 3m away from the fan
Use the remote closer to the
fan and make sure it is pointing
directly at the fan base
There is a ‘h’ on the display
‘h’ stands for hours and will be
seen on the display when the
timer is being set
Press the timer button until ‘00’
is shown on the display
– this
will remove the timer
