7
ME-MOVER.COM
TO ASSEMBLE YOUR ME-MOVER FIT 2.0, FOLLOW THESE
STEPS:
1. Place the cardboard box on the floor and use this as an underlay during
assembly.
2. Open the steering column quick release and pull out the inner steerer from the
steering column.
Pull the inner steerer out by 10cm. Tighten the quick release clamp
again so the inner steerer does not slide back down. Use a 5mm Hex Key to take out the
end plug.
3. Mount the handlebar stem on the inner steerer and tighten the two screws using
a 4mm hex key. Re-insert the end plug.
Do not overtighten these screws beyond
5Nm.
WARNING
!
Do not tighten the screws with more than 5Nm. 5Nm corresponds to a 20cm long
wrench with a force of 2.5kg.
Handlebar stem
Inner steerer
End plug
Steering column
quick release OPEN
Steering column
quick release CLOSED
Inner steerer
End plug
10 cm
NOTE: Lubricate the inner steerer with oil or grease.
