Technical Manual
LED-Indicator
SCN-LED55.01/SCN-GLED1x.01
MDT technologies GmbH •
51766 Engelskirchen • Papiermühle 1
Phone: +49-2263-
880 • Fax: +49-2263-4588 • [email protected] • www.mdt.de
16
16
The following table shows the available settings:
ETS-text
Dynamic range
[default value]
comment
Color setting
▪
red
▪
green
▪
blue
▪
white
Adjustment of the LED color
Behavior of indicator
▪
light on
▪
blinking
▪
flash
Adjustment of the light behavior:
light on:
light on = switched on permanently
blinking = flashing rhythm 1:1
flash = short on, long off
Indicator by day
▪
off
▪
dark
▪
bright
Adjustment of the light behavior at day.
Only adjustable if the day/night object is
active(General settings)
Indicator by night
▪
off
▪
dark
▪
bright
Adjustment of the light behavior at night.
Only adjustable if the day/night object is
active(General settings)
Table 7: Display behavior LED
The settings for the LED display behavior behavior are identical for the setting with LED object value
1, as well as for the LED priority settings.
4.2.3 LED Priority
By using the LED priority, it is possible to switch the LED of prime importance. So the value of the
normal LED control will be overwritten. Two LED priorities are available. The priority of the LED
controlling is staggered as follows (from high to low priority): LED Priority 1
→
LED Priority 2
→
normal LED Control.
The settings for the LED priority (settings for Led priority 2 are identical) are as follows:
