MDS Power IPSi2400X, Руководство по установке и эксплуатации

Страница: 8 / 16

8
MOUNTING
Mount the inverter on a horizontal surface in
a WELL VENTILATED and DRY area with at
least 1 inch (2.54 cm) of clearance all around
the unit.
CAUTION: THE UNIT MUST BE
MOUNTED ON A FLAT HORIZONTAL
SURFACE .
The heavy-duty toroidal power transformer
inside the inverter weighs 50+ pounds. Unless
the unit is mounted horizontally, it could break
free from its single mounting bolt under severe
vibration.
GROUNDING
The unit case is connected to AC Ground and AC Neutral in order to meet regulatory
requirements and reduce the possibility of it generating any radio frequency interference.
The unit case must be bonded appropriately to the grounding system of the vehicle or marine
vessel. On a vehicle, bond the case to the vehicle’s frame. On a marine vessel, bond the case
to the vessel’s hull. A grounding stud is provided on the front panel for this purpose.
To ensure proper grounding, check the connection with an ohmmeter. The case is isolated from
the DC input, so the DC power can be connected to a different ground from the AC output.
DISCONNECTING
If you need to disconnect the inverter for service or storage:
1. Move the power switch to OFF and disconnect the DC power source.
2. With power disconnected, move the power switch to ON.
3. Leave the switch in this position for one minute to discharge the storage capacitors.
4. Return the power switch to the OFF position. Disconnect the load(s).
5. The inverter is ready for service or storage.
Installation