(1300 494 494)
2
(1300 494 494)
3
1300 4X4 4X4
1300 4X4 4X4
www.marketdirect.com.au
www.marketdirect.com.au
CONTENTS
SET UP – OPERATION
∑
Brake Controller – Hitch
∑
Front Door
∑
External Kitchen
∑
Hot Water System
∑
Filling Water Tanks
∑
Stove/Oven/Grill
OPTIONS
∑
Air Conditioner
ELECTRICAL SYSTEM
∑
What Makes Up Your Electrical System
∑
Operation Essentials
∑
Main Switch Board 12v
∑
240v Inverter
CHARGING YOUR BATTERIES
∑
Vehicle
∑
240v
∑
Solar
∑
Battery Voltage
∑
General Tips
WARRANTY INFORMATION
∑
Details
∑
Claims
∑
Warranty Limitations
∑
Owners Responsibility
CARE & MAINTENANCE
∑
General Care
∑
Care For Your Van
∑
Brakes & Bearings
DEPARTURE CHECKLIST
∑
Before You Leave Checklist
DRIVING RECOMMENDATIONS (GUIDE ONLY)
INTRODUCTION
Some of the conditions that you may encounter during your travels can cause damage to your van if
you do not take appropriate actions. MDC has the following recommendation for some of these
conditions.
DIRT ROAD
Reduce speed and reduce all tyre pressures on both the van and vehicle to 25psi cold or if the tyres
are hot use 30psi. This will increase the tread area of the tyres and provide better road holding. You
will encounter fewer punctures and less vibration damage to both vehicles.
CORRUGATED DIRT ROAD
Reduce speed and reduce all tyre pressures on both the van and vehicle to 25psi cold or if the tyres
are hot use 30psi. This will increase the tread area of the tyres and provide better road holding. You
will encounter fewer punctures and les vibration damage to both vehicles.
SAND DRIVING
Reduce speed and reduce all tyre pressures on both the van and vehicle to 18psi. Try to drive on
harder sand, maintain the momentum of your vehicle while negotiating soft sand and stay in the
wheel ruts as they are usually harder than the soft sand. If your vehicle allows, select low range for
beach access and high range 4WD for hard sand driving. It is advisable to turn the brake controller
off as sudden stopping can bog the trailer.
RIVER CROSSINGS
Allow 20 minutes cooling of your bearings before river crossings. Always
check and regrease bearing after crossings as required.
