MDC FORBES 13 2015, Руководство пользователя

Страница: 26 / 101

www.marketdirect.com.au
I
Ph: 1300 494 494
I
©Copyright P a g e | 26
Stabiliser Legs
Stabiliser legs are installed to stabilise the caravan or camper when setup. Stabiliser legs should never be
used to jack a trailer as they are comprised of small bevel gears held in place by small roll pins that will
break if overloaded. Stabilisers are best set vertical or 90 degrees to the chassis where possible. When set
and an angle the user must be careful not to overload them causing locking pins or the leg itself to bend.
Never use impact wrenches to wind the legs, the impact may damage the gears. When using a power
tool, use an electric drill with a safety clutch set low to medium to avoid injury or damage to the
stabilisers.
Electric Awning
When extending the awning always support to front as it extends. Do not allow the awning to carry the
full extended weight as this may damage the hinges. Support the end manually by hand or by using the
extendable legs. Never allow water to pool on the awning, during rain lower one side to a level that
allows the water to freely run off and not pool. In light to moderate breeze guy ropes should be used. In
stronger winds the awning should be retracted completely. Always set the awning for wet conditions if
leaving up overnight in case of unexpected rain. If high winds are possible, pack the awning away
overnight. It is your responsibility to know the weather prediction.
During rain, the awning should be lowered on one side as illustrated below.