MD Helicopters 369-500, Инструкция по техническому обслуживанию

Страница: 460 / 722

CSP-HMI-3
MD Helicopters, Inc
.
MAINTENANCE MANUAL
[ Main Menu ]
[ HMI − 3 Book TOC ]
[ Chapter 96 TOC ]
Page 202
Revision 8
96-05-10
The information disclosed herein is proprietary to MD Helicopters, Inc.
Neither this document nor any part hereof may be reproduced or transferred to
other documents or used or disclosed to others for manufacturing or any other
purpose except as specifically authorized in writing by MD Helicopters, Inc.
Copyright
©
1999 − 2016 by MD Helicopters, Inc.
G96-0010
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
Figure 201. Arrangement and Busing
8. Battery Replacement
(Ref. Figure 202)
(1). Ensure that all electrical power is off.
(2). Raise pilot's floor (left side) compart­
ment access door.
(3). Disconnect battery connector.
(4). Remove screws and washers attaching
battery mounting brackets to support
assemblies.
(5). Lift battery, with cover in place, out of
battery compartment. (Place battery in
a protected area away from any
lead-acid battery or equipment used to
service lead-acid batteries.)
Before installing replacement
battery, ensure that battery is
charged and shorting straps are removed.
(6). Position replacement battery mounting
brackets on battery support assemblies.
Connector on battery box should be
facing aft. Attach mounting brackets to
support assemblies with screws and
washers removed in step (4).
(7). Attach battery wire harness connector
to connector on battery box.
(8). Close compartment access door.
CAUTION