www.mcohome.com
User Manual
MCOHome Technology Co., Ltd
2
Notice!
1. Device must be wall-mounted vertically. Do not lay it
flat or upside down while working.
2. Do not mounted it in a wind gap, or cover its bottom,
which may affect the detected data.
Step 1:
Separate Panel and Bottom case by removing the screw at the bottom of device. Insert all
wires into the right terminals inside the bottom case and tighten screws. The wiring
diagram is shown above.
Pay attention to the current direction of positive and negative, otherwise device will easily be burn!
Step 2:
Mount the Bottom case onto wall with two screws (M4*25mm). The hole pitch 60mm is for
86/60mm box, and 82mm is for American 120mm box.
Step 3:
Mount the Panel back by aligning its tabs and card slot onto the Bottom case.
Step 4:
Tighten the fastening screw and the device is ready for normal work.
Button & Display
Hold K2 3Sec to check the Node ID
Hold K1 3Sec to set the local time
