www.mcohome.com
User Manual
MCOHome Technology Co., Ltd 2014
2
Keep the device away from acid-base and other corrosive solids, liquids, gases, to avoid
damage.
Avoid overexertion during operation, to protect device from mechanical damage.
Read all instructions and documentation and save for future reference.
Installation & Wiring
Location:
Thermostat is suggested to be installed indoor, a place with around 1.5m height above the
floor where represents the average room temperature. It should be away from direct sunlight, any
cover, or any heat source, to avoid false signal for temperature control.
CAUTION: Cut off power supply at circuit breaker or fuse before installation to avoid fire,
shock or death!
Step 1:
Separate the device into two parts: the display
panel and the bottom.
Step 2:
Insert all wires into the right terminals and
tighten screws. Wiring diagrams are shown below.
Step 3:
Push the bottom into the junction box and
secure it with two screws, and then mount the touch
panel back.
Step 4:
Confirm the device is well mounted, power on and it is ready to operate.
(1) Wall-boiler
(2) Normal close valve
(3) Electrical heating
Button & Display
