www.mcohome.com User Manual
MCOHome Technology Co., Ltd
2
Operation
INCLUDING the device into Z-Wave network
1.
Set controller into INCLUSION mode. Follow instructions provided by controller manufacturer.
2.
Press and hold the key on the panel for 8 seconds.
Note: If inclusion is successful, INDICATION LED on the panel will turn green, and switch will turn
on.
EXCLUDING the device from Z-Wave network
1.
Set controller into EXCLUSION mode. Follow instructions provided by controller manufacturer.
2.
Press and hold the key on the panel for 8 seconds.
Note: If the exclusion is successful, INDICATION LED on the panel will turn orange, and switch will
turn off. The exclusion will delete all association data.
Turning on/off the Touch Panel Switch
The Touch Panel Switch can be controlled by:
Pressing the key.
Sending commands through controller or gateway.
（
the command classes which support this
function are Basic Command Class, Binary Command Class, Switch All Command Class, and
Multi Channel Command Class.
）
Multi Channel Control:
The switch can be controlled by command “MULTI_CHANNEL_ENCAP” in the command class
“COMMAND_ CLASS_MULTI_CHANNEL”.
Byte
Name
1
COMMAND_CLASS_MULTI_CHANNEL
2
MULTI_CHANNEL_CMD_ENCAP
3
Source End Point
4
Destination End Point
5
COMMAND_CLASS_SWITCH_BASIC or COMMAND_CLASS_SWITCH_BINARY
6
BASIC_SET/BASIC_GET or BINARY_SET/BINARY_GET
7
Value ( 0xFF -- ON 0x0 -- OFF )
Multi Channel Association:
To set association groups by the command “COMMAND_CLASS_MULTI_CHANNEL_
ASSOCIATION”.
The device supports 2 association groups (AG). The 1
st
AG is used for reporting devices’ state to
the controller if any changes happen. This group supports one Node, which suggested to be controller
Node. The 2
nd
AG is used for switching associated devices
，
and it can support up to 5 nodes or
terminals.
For the 1
st
AG, a report will be sent to associated controller when any state changes happen in
other group(s). For the 2
nd
AG, the touch panel switch will send Basic Set Command to related
association groups when setting switch state by gateway or key-pressing. Then the switch states of
associated devices and their related key will be synchronic.
