www.mcohome.com User Manual
MCOHome Technology Co., Ltd
2
Step 3 Installation
Step 1:
Remove the steel frame from the device, and secure it onto the junction box with two screws.
Step 2:
Insert all wires into the right terminals and tighten screws.
Step 3:
Attach the wired device on “A” points of the steel frame as shown first, and then push the
whole device into junction box.
Step 4:
Confirm the device is well mounted, power on and it is ready to operate.
Operation
INCLUDING the Touch Panel Switch into your network
1.
Set controller into INCLUSION mode. Follow instructions provided by controller manufacturer.
2.
Press and hold any key on the panel for 8 seconds.
Note: If inclusion is successful, all INDICATION LEDs on the panel will turn green, and all switches
will turn on.
EXCLUDING the Touch Panel Switch from your network
1.
Set controller into EXCLUSION mode. Follow instructions provided by controller manufacturer.
2.
Press and hold any key on the panel for 8 seconds.
Note: If the exclusion is successful, all INDICATION LEDs on the panel will turn orange, and all
switches will turn off. The exclusion will delete all association data.
Turning on/off the Touch Panel Switch
The Touch Panel Switch can be controlled by:
Pressing any key.
Sending commands through controller or gateway.
（
the command classes which support this
function are Basic Command Class, Binary Command Class, Switch All Command Class, and
Multi Channel Command Class.
）
Multi Channel Control
The switch can be controlled by command “MULTI_CHANNEL_ENCAP” in the command class
“COMMAND_ CLASS_MULTI_CHANNEL”.
