McNeilus HD Rear Loader, Руководство оператора

Страница: 61 / 132

© 2008 McNeilus Truck and Manufacturing, Inc.
Rear Loader
47
Operation
2.1.1 E-STOP Button In-Cab Control Box
The E-STOP on the control box has two position: DOWN
(Figure 15, Item 1) to disable refuse vehicle functions, and UP
(Figure 15, Item 2) for normal operation.
NOTE
If your rear loader has the optional side door
ladder, the door will be equipped with a
proximity switch. The proximity switch will
stop hydraulic functions during normal
operation if the side door is opened. To
resume hydraulic functions, the side door
must be closed and the pump switch must
be pressed to enable hydraulic functions.
1
2
Figure 15
2.2 Sweep Functions
The packing cycle of the sweep panel (Figure 16) is controlled
by the sweep lever located in the external rear controls group
on the curb side of the vehicle. The operator must follow ANSI
Z245.1 packing and material handling controls standard,
which includes directives that all personnel are clear of the
hopper before starting any packing cycle or material handling.
The operator must remain at the controls during the packing
cycle and be ready to stop the packing cycle if there is a
potential point of operation hazard.
DANGER
Use extreme caution around the sweep and
slide area on the rear of the vehicle. Be sure
the area in the hopper is clear before
operating the controls.
Serious personal injury or death may result if
someone is caught in the sweep or slide
panels.
CONDITIONS
• E-STOP(s) pulled OUT
• Pump switch ON
• Ensure that the side door is closed if equipped with side
door proximity switch
• Engine speed must be below 1400 RPM