McLaren SUPER SERIES, Руководство пользователя

Страница: 196 / 268

Maintaining Your McLaren
Fluid Topping Up
6.2
Maintaining Your McLaren Fluid Topping Up
Engine oil
The engine uses approximately 0.1 litres of
oil for every 625 miles (1,000 km),
depending on your style of driving. The oil
consumption may be higher than this when
the vehicle is new or if you frequently drive
at high engine speeds.
You will only be able to estimate the oil
consumption after the vehicle has been
driven for several thousand miles or
kilometres.
NOTE: Lubricant additives could
damage the engine or gearbox.
Damage caused by such additives is
not covered by the vehicle warranty.
Further information is available from
your McLaren retailer.
Checking the engine oil
1. Ensure the following conditions are
met:
•
Vehicle stationary and positioned
on a level surface.
•
Neutral selected and the foot brake
applied (use left foot).
NOTE: The foot brake must be applied
for the entire duration of the oil level
check.
2. The level is viewed in the Vehicle Info
section on the Driver Display, see Oil
status, page 3.7.
3. Start the engine and hold the engine
speed at 2,000 rpm for 120 seconds.
Allow the engine oil temperature to
reach a temperature of 90°C (194°F).
NOTE: The throttle can be fully
depressed as the engine speed will be
electronically limited to 2,000 rpm.
4. When the timer has reached ‘0’, the oil
level will be shown on the Driver Display
along with a description.
NOTE: The line on the display indicates
the maximum oil level for 19 seconds
after the oil level is read.
5. If the engine oil is below the target
level, top up the oil in accordance with
the following procedure.
p14.book Page 2 Tuesday, October 24, 2017 11:15 AM