TECHNICAL NOTE – OPERATION OF MT4400 TWTA
08/10/2004
TN4400-3
MCL, INC.
22 of 36
45A0189 may differ slightly
On this screen some parameters are displayed only, others can be modified individually. The
“Control Mode” set button is nonfunctional on the MT4400.
4.7.3
Uploading Settings to the HPA
1.
The HPA must be in a maintenance mode (the HPA is not transmitting on the antenna). It
must be in Local and not carrying traffic or an interruption in service may occur.
The HPA must be in a maintenance mode to upload settings or an
interruption of service may occur.
2.
On the Diagnostic Interface program click on the “Settings” tab (see the figure above).
3.
If necessary, insert the disc into the PC which contains the settings file.
4.
Click on the “File” menu, select “Open” on that menu, then on the Open menu select
“Settings,” then select the setting file and click OK.
5.
Click on the “Set All” button.
6.
The status bar on the bottom of the screen should say “Cmd: Accepted” when the upload
is complete.
CAUTION
