12
McIntosh Single Channel Amplifier Number One
How to Prepare Hookup Cables
The McIntosh XRT29 Loudspeaker System utilizes bind-
ing posts for speaker wire connections. Prepare the Loud-
speaker Hookup Cables that attach to the Power Amplifier
Output Terminals:
Bare wire cable ends:
Carefully remove sufficient insulation from the cable
ends, refer to figures 20, 21 & 22. If the cable is
stranded, care-
fully twist the
strands to-
gether as
tightly as pos-
sible.
Note: If desired, the twisted ends can be tinned with
solder to keep the strands together and/or attach a
spade lug.
Spade lug or prepared wire connection:
Insert the spade lug connector or prepared section of
the cable end into the terminal side access hole, and
tighten the terminal cap until the cable is firmly
clamped into the terminal so the wires cannot slip out.
Refer to figures 23, 24 & 25.
How to Connect using two Amplifiers
1. Remove the jumpers from between the MID and HIGH
Binding Posts on the XRT29 Column Loudspeaker and
save them for possible future use.
2. Connect a Loudspeaker Cable from the Negative (-)
Binding Post of the Amplifier Number One to the
XRT29 Column Loudspeaker MID COMmon (-) Bind-
ing Post.
Note: If the XRT29 Column is installed into a wall,
use the MID IN-WALL Binding Posts instead of
the Column MID Binding Posts.
3. Connect a Loudspeaker Cable from the Positive (+)
Binding Post of the Amplifier Number One to the
XRT29 Column Loudspeaker MID 4
S
(+) Binding
Post.
4. Connect a Loudspeaker Cable from the Negative (-)
Binding Post of the Amplifier Number Two to the
XRT29 Column Loudspeaker HIGH COMmon (-)
Binding Post.
5. Connect a Loudspeaker Cable from the Positive (+)
Binding Post of the Amplifier Number Two to the
McIntosh Single Channel Amplifier Number Two
XRT29 Column Loudspeaker HIGH 4
S
(+) Binding
Post.
6. Tighten all of the Loudspeaker and Amplifier Binding
Posts.
