14
How to Connect using Three Amplifiers
2. Remove all four metal jumpers between Loud-
speaker Binding Posts.
3. Connect a Loudspeaker cable from the XCS200
LOW Frequency COM Binding Post to the
COM (-) Binding Post of the Power Amplifier
Output One.
Note: It is important to maintain the correct
polarity at both ends of the Loud-
speaker cables.
4. Connect a Loudspeaker cable from the XCS200
LOW Frequency 8Ω Binding Post to the 8
ohm (+) Binding Post of the Power Amplifier
Output One.
5. Connect a Loudspeaker cable from the XCS200
MID Frequency COM Binding Post to the
COM (-) Binding Post of the Power Amplifier
Output Two.
6. Connect a Loudspeaker cable from the XCS200
MID Frequency 8Ω Binding Post to the 8 ohm (+)
Binding Post of the Power Amplifier Output Two.
7. Connect a Loudspeaker cable from the XCS200
HIGH Frequency COM Binding Post to the COM
(-) Binding Post of the Power Amplifier Output
Three.
8. Connect a Loudspeaker cable from the XCS200
HIGH Frequency 8Ω Binding Post to the 8 ohm
(+) Binding Post of the Power Amplifier Output
Three.
9. Tighten all of the Loudspeaker and Amplifier
Binding Posts.
Caution: The AC Power Cord should not be connected
to the Power Amplifiers until after the Loud-
speaker Connections have been made. Failure
to observe this could result in Electric Shock.
When connecting the XCS200 Loudspeaker to ampli-
fiers, it is very important to use cables of adequate
size so there is negligible power loss in the cables. The
size is specified in Gauge Numbers or AWG (Ameri-
can Wire Gauge). The smaller the Gauge number, the
larger the wire size:
Loudspeaker Cable Distance vs Wire Gauge Guide
Loudspeaker
Impedance
25 feet
(7.62 meters)
or less
50 feet
(15.24 meters)
or less
100 feet
(30.48 meters)
or less
8 Ohms
16AWG
14AWG
12AWG
1. Prepare Loudspeaker cables by choosing one of the
methods below:
Bare wire cable ends:
Carefully remove sufficient insulation from the
cable ends, refer to figures 30, 31 & 32. If the
cable is
stranded,
carefully
twist the
strands
together
as tightly as possible.
Note: If desired, the twisted ends can be tinned
with solder to keep the strands together or
attach spade lugs.
Spade lug or prepared wire connection:
Insert the spade lug connector or prepared
section of the cable end into the terminal side
access hole, and tighten the terminal cap until
the cable is firmly clamped into the terminal so
the wires cannot slip out. Refer to figures 33, 34
& 35.
Figure 30
Figure 31
Figure 32
Figure 33
Figure 34
Figure 35
Power Amplifier number One
