15
Tone Arm
9” vertical Yoke type tonearm with lateral type
bearing
Damped machined aluminum tube arm
Pivot to spindle
223mm
Effective length
240.7mm
Overhang
17.7mm
Offset angle
22.85 degrees
Average RMS distortion
.36%
The Table
3/8-inch Thick Glass anchored to custom 1/4-inch
thick aluminum metal plate for stability
Aluminum Platter
Platter rotates on an oil bath bearing
The bearing has a high performance
polyetheretherketone (PEEK) thrust disc and
machined graphite impregnated brass bushings
using a Thompson Engineering 60 Rockwell case
hardened shaft
Motor
600 RPM Direct Drive Permanent Magnet AC
Synchronous Motor AC - 2 speed pulley
Turntable Speeds
33.3 RPM and 45 RPM
General
Power Requirements
Refer to the rear panel of the MTI100 for the
correct voltage. The MTI100 is factory configured
for one of thefollowing AC Voltages:
100 Volts, 50/60Hz at 50 watts
110 Volts, 50/60Hz at 50 watts
120 Volts, 50/60Hz at 50 watts
127 Volts, 50/60Hz at 50 watts
220 Volts, 50/60Hz at 50 watts
230 Volts, 50/60Hz at 50 watts
240 Volts, 50/60Hz at 50 watts
Standby Power, less than 0.25 watts
Field AC Voltage conversion of the MTI100 is not
possible.
Dimensions
Width 19-1/4 inches (48.9cm)
Height 6-3/4inches (17.15cm) including feet
Depth 14 inches (35.6cm) including antenna
Weight
33.5 pounds (15.2 kg) net
40.5 pounds (18.4 kg) in shipping carton
Shipping Carton Dimensions
Width 24 inches (68.6cm)
Height is 16-1/2 inches (35.6cm)
Depth is 17-1/2 inches (63.5cm)
Trademark Logo
License
Information
The Bluetooth® word mark
and logos are registered
trademarks owned by
Bluetooth SIG, Inc. and
any use of such marks
by McIntosh Group, Inc.
is under license. Other
trademarks and trade names
are those of their respective
owners.
Trademark and License Information
The McIntosh MTI100 incorporates copyright
protected technology that is protected by U.S. patents
and other intellectual property rights. The MTI100
uses the following technologies:
