12
How to Operate the MA6500 cont
Speakers 1 and 2
Press SPEAKERS 1 or 2 push-buttons to switch the two
pairs of speakers on or off. You can press either push-but-
ton individually, or both together. Refer to figure 5.
Headphones
Jack
Connect a pair
of dynamic
headphones to
the Headphones
Jack for private
listening. Press
Mute to mute
all other outputs
including the amplifier connected to the loudspeakers. Re-
fer to figure 5.
Reset of Microprocessors
In the event that the controls of the MA6500 stop function-
ing, push the POWER switch OFF and wait about two min-
utes. Then push the POWER switch ON followed by push-
ing the STANDBY/ON push button. This will reset the
MA6500 microprocessors and the Integrated Amplifier
should be functioning normally.
Note: The above condition is usually caused by either
interruptions in AC power and/or major changes that
may occur in AC power line voltage.
Using a Separate Power Amplifier
There are two different ways to use a separate power am-
plifier with a MA6500. The first way is to use the separate
amplifier instead of the MA6500 built-in power amplifier.
Connect the loudspeakers to the separate power amplifier
and set the rear panel POWER AMP INPUT Switch to the
EXT position. Refer to figure 6.
Note: When a separate power
amplifier is connected to
the MA6500 and the
POWER AMP INPUT
Switch to the EXT
position, the MA6500
Front Panel SPEAKERS
Push-button Switches
will no longer function.
The second way is to use both a separate power amplifier
and the MA6500 built-in power amplifier. Connect one
pair of loudspeakers to the separate power amplifier and
the second/third pair to the MA6500. Set the rear panel
POWER AMP INPUT Switch to the INT position. Refer to
figure 6.
Note: The MA6500 VOLUME Control will affect the sound
level of all the loudspeakers.
How To Make A Tape Recording
1. Select the source signal you wish to record with the
appropriate Front Panel input push-button. If you wish
to record from an Audio/Video source connected to the
optional MVS-3 Audio/Video Selector, using the Re-
mote Control, select the desired source connected to
the MVS-3. Refer to figure 8.
2. Adjust the record level using the tape recorder volume
control and proceed with the recording process.
3. To listen to the tape playback of the program source
just recorded, press the TAPE input push-button. Refer
to figure 7.
Note: The MA6500 TAPE OUTPUTS are not affected by the
VOLUME or BALANCE controls.
<>=>
B?40:4AB
!
C0?4
7403?7>=4B
?>F4A6D0A3
;45C
A867C
10;0=24
1
7
Figure 5
Figure 6
23!
23
CD=4A
E834>
?7 0DG
C0?4
CA41;4
10BB
Figure 7
All manuals and user guides at all-guides.com
