15
How to Operate the MA6300
When the MA6300 has returned to a safe operating
temperature, normal operation will resume.
How To Make A Tape Recording
1. Select the signal you wish to record with the appro-
priate Source Push-button.
2. Adjust the record level using the recorder volume
control and proceed with the recording process.
3. To listen to the playback of the program source just
recorded, press the TAPE Push-button.
Note: The MA6300 TAPE OUTPUTS are not affected
by the VOLUME or BALANCE controls.
Reset of Microprocessors
In the unlikely event the controls of the MA6300 stop
functioning, the microprocessors can be reset by per-
forming the following:
1. Press and hold in the STANDBY/ON Push-button
for approximately five seconds.
2. When the MA6300 cycles On then Off, release the
STANDBY/ON Push-button.
3. When the STANDBY/ON LED is illuminated
press the STANDBY/ON Push-button, the
MA6300 will resume normal operation.
Note: This can be performed with the MA6300 On or
in the Standby Mode.
Figure 9
Note: For an explanation of the Remote Control Push-
button functions, refer to pages 16 and 17.
