McIntosh HR070 Series, Руководство по программированию

Страница: 5 / 22

5
Verify Programmed Codes
At any time, an already entered code to operate a
specific component can be verified. For example, to
find out which code is assigned to your TV perform
the following steps:
1. Press TV once.
2. Press and hold SETUP Push-button until the
Push-button blinks twice, then release.
3. Enter 9 9 0. The Push-button blinks twice.
4. To view the first digit of the stored code press 1.
Count the light blinks (for example, three blinks =
3), and write down the number.
Note: If a code digit is 0, the Push-button does
not blink.
5. Repeat step 4 for the four remaining digits, using 2
for the second digit, 3 for the third digit, 4 for the
fourth digit, and 5 for the fifth digit.
6. To check for other component, repeat steps 1—5,
substituting the component push-button you would
like to check.
Programming the Remote Control
Diagnostic Assistance
Difficulty Suggested Remedy
does not blink when
you press a Push-button
Try pressing other push-
buttons; replace the bat-
teries
blinks when you press
a key, but device does not
respond
Make sure the remote
control is aimed at your
component and is not more
than 40 feet away
blinks one long blink
while in SETUP mode
An entry error has occurred
(for example, pressing the
wrong push-button); try
entering the sequence again
Difficulty Suggested Remedy
Remote Control does not
control component or
commands are not working-
properly
Try all listed codes for the
component; make sure the
component operates with
the original remote control
CH+, CH-, and LAST do
not work for your RCA TV
Due to design of RCA TVs
from 1983 to 1987, only
the original TV Remote
Control will operate these
functions
Channels do not change
properly when directly
entering digits to change
channels
If the original remote con-
trol required you to press
Enter to change channels,
press SELECT on the
McIntosh Remote Control
after entering the channel
number
Restoring Default Settings
In the unlikely event the Remote Control no longer
controls McIntosh Components (the default McIntosh
Command Codes were accidentally deleted) follow the
steps below to restore them:
1. Press Push-button on the Remote Control to
be restored to default Command Codes. Refer to
figure 5.
2. Press and hold SET Push-button until the Push-
button illumination blinks twice, then release.
3. Enter the five-digit code (using the numeric push-
buttons) for the version of the McIntosh Remote
Control (model number is located near the bottom
of the remote control)
Note: If the McIntosh Component the Remote
Control came with was changed (in the Setup
Mode) to respond to the “Alternate Control
Codes” then enter the Alternate Control Code
five digit number instead of the Normal Con-
trol Code Number.
HR Series Remote Control Programming
Remote Control
Model Number
Normal or
Alternate Code
Code Number
HR070 or HR071 Normal 32428
HR070 or HR071 Alternate 32429
HR072 Normal 32436
HR072 Alternate 32437
HR073 Normal 32431
The Push-button blinks once as each digit
is entered. If the code is valid, the Push-button
blinks twice.
Note: If the Push-button does not blink twice, repeat
steps 2 to 4 and try entering the code again.
4. Aim the Remote Control at the McIntosh Compo-
nent and verify normal operation using the remote
control.