Check List PRIOR to Operation
•
Never run forage wagon at over 36 kph as damage could occur.
•
Remove wires holding the centre feed discharge flaps. These have been used
for transportation purposes only.
•
Adjust centre feed flaps to approximately 600mm. This measurement will vary
depending on type of material being fed out.
•
Look over all bolts to check none have come loose after transport from
factory.
•
Check all wheel nuts for tightness.
•
Connect hydraulic hoses to tractor, run up machine, and check slow and fast
feeds of floor chains.
•
Please show all persons operating this machine the manual before operating
for the first time.
The first time you use your wagon, if the floor does not move forward, screw the
bronze pressure valve knob which is under the valve, in ½ a turn at a turn until
the floor starts to move forward.
NOTE: ALL MACHINES ARE RUN UP PRIOR TO LEAVING THE FACTORY
BUT THE ABOVE STEPS SHOULD BE DONE PRIOR TO USE
