Problem: Fork assembly will not return to fully dropped (loading) position
or rear forks creep down when carrying a Bale.
Return sequencing
valve located here
Standard Factory settings 3.5 to 4 turns out
If the fork assembly is not returning to the load position during operation, screw the return valve
out a half a turn at a time until the operation works correctly. Normally this valve is set at 3.5 to 4
turns out. If this valve is screwed too far out, the main lift ram can drop when carrying a bale.
If this occurs, screw the valve in until the ram holds the bale. Always tighten the lock nut to stop the
oil from leaking.
POWER PACK INSTRUCTIONS
1.
Turn main power switch on, green light will come on.
2.
Turn key to on.
3.
Use choke when motor is cold.
4.
Press remote button
1
then start.
5.
To stop press button
2.
6.
Press button
5
to lower forks.
7.
Press button
6
to load bale.
8.
Press button
7
to feed out left side.
9.
Press button
8
to feed out right side (drivers side).
Содержание Double Bale Feeder
Страница 12: ......
