4
Fine Tune
The Tweeter/Midrange Driver Array can be rotated around
the edge of the CS200 to make fine adjustments. Loosen
the two screws on either side of the tweeter a few turns.
This will allow the Array to slide back and forth slightly.
When the optimum position is determined through careful
listening, tighten the two screws.
Larger adjustments can be made by loosening the four
clamping screws and rotating the entire CS200. Be sure to
re-tighten screws when done.
Speaker Diagram
Figure 1.1- CS200 requires a 9 5/8 inch (24.4475 cm)
hole with a
depth of at least 5 inches (12.7cm).
Figure 1.2- Retracted clamps will extend with one counter-clockwise
turn of the clamping screws seen below..
