3
Installation
Figure 6
Figure 7
Figure 10
Screw location
Figure 11
Bracket location
Unpacking the Column
13. Remove the banding material from the shipping car-
ton. Refer to figure 6.
14. Lift off the top of the
shipping carton and
set it aside.
15. Lift up on the rear of
the Column Loud-
speaker, near the foam
packing material at
both ends. Place the
entire assembly (Col-
umn, Loudspeaker
Grille and foam pack-
ing material) next to
the bottom shipping
carton on a flat sur-
face. Refer to figure 7.
16. Release the Loudspeaker Grille from the packing
material by opening the slit in the packing material
located on the top center. Store the Loudspeaker
Grille in a safe location for possible future use.
17. In a similar manner, lift out the Loudspeaker Column
and set it aside.
18. Replace the shipping carton top onto the shipping
carton bottom. Take the two center pieces of the just
removed packing material and lay it down flat onto
the top of the shipping carton.
19. Carefully remove the protective shipping bag(s) from
the Loudspeaker Column so as not to mar the Col-
umn Finish or damage the Loudspeaker Drivers.
Installing the Loudspeaker Column
20. Place the Loudspeaker Column on top of the packing
material located on top
of the shipping carton
making sure to align
the Column Bottom
End (the Glass Name
Plate end) to the end of
the shipping carton.
Refer to figure 5.
21. Using the supplied Allen Wrench, remove the Glass
Plate and Spacer Board from the front bottom of the
Loudspeaker Column. Refer to figure 8.
Note: Save the Glass Plate, Spacer Board and four flat
head screws for possible future use.
22. Install eight round head screws (four from the just
removed Glass Panel and four additionally supplied)
into the openings on the bottom front of the Loud-
speaker Column.
23. Rotate the Loudspeaker Column face down on top of
the packing material. Refer to figure 9.
24. Remove and set aside the twenty screws from the
rear of the Loudspeaker Column. Refer to figure 10.
25. At the locations where the just removed screws came
from, attach the five In-Wall Brackets to the rear of
the Loudspeaker Column. Refer to figure 11.
Figure 9
Rear Panel Connections
Figure 8
