McHale
991L
Round Bale Wrapper
46
Remote Type
This option is used to select the remote control type. There are 2 different types used:
Infrared (IR) - Older machines
Radio frequency type (RF) - Newer machines
To select the remote type:
1.
Press the Down Arrow (Button 4) three times, to select the Operator Setup
Menu
2.
Press Enter (Button 3)
3.
Press the Down Arrow (Button 4) four times and press Enter
4.
Select either IR/RF/RF Learn, as appropriate
5.
Press Enter (Button 3) to save the selection
Infrared Remote
Whenever an Infrared remote type is being used, select “IR” in the Remote Type Menu,
as above. Connect the receiver to the serial port on the Electronic Control Box and
select Auto mode (Button 13). The cycle can be started by pointing the infrared remote
at the receiver and pressing the Auto Start Button (See Figure 8.d). The Emergency
Stop Button will stop the cycle at any time. The other two buttons will rotate the table
in forward and reverse.
Radio Remote
Whenever a radio remote is being used for the first time, the remote frequency code
must be “learned” by the Electronic Control Box. Select “RF LEARN” in the Remote
Type Menu and connect the receiver to the serial port on the Electronic Control Box
and select Auto mode (Button 13). Press the Stop Button on the radio remote (See
Figure 8.f). A code will appear on the screen of the Electronic Control Box to show that
the radio frequency code has been stored. ESC (Button 2) can then be pressed to
return to the working screen and the remote is ready to use.
This procedure only needs to be followed when the remote handpiece is used with an
Electronic Control box for the first time. The “RF” type will be automatically used once
Figure 8.c - Infrared Receiver
Figure 8.d - Infrared Remote
Table
forward
rotate
Auto
start
Emergency
stop
Table
reverse
rotate
