McElroy Hot Tap Tools, Руководство оператора

Страница: 11 / 22

3 - 2
Hot Tap Operation
Mark Insertion Depth
Holding the housing assembly next to the pipe being attached
to, align the line near the end of the housing assembly with the
end of the pipe. Make a mark that is in-line with the end of the
housing assembly.
TX05250-02-28-17
Inspect Tooling
Inspect the grip plates in housing assembly. The plates must be clean
to prevent slippage and ensure proper fit. Clean the plates of any dirt
or residual material.
NOTICE: All four Grip Plates and spring must be in place before using
Hot Tap Tool.
Verify that the size marked on the housing assembly matches the size
of the pipe being attached to.
The O-ring is lubricated with silicone lubricant for ease of pipe
installation. It may be necessary to lubricate the O-ring periodically.
Use only Parker Super-O-Lube®. The lubricant is not intended to
provide extra sealing capability.
Lubricating the O-ring:
1. First, remove the plates, one at a time, and then remove the spring.
2. Inspect the O-ring in the housing assembly for signs of damage. If
an O-ring is scored or cut, it must be replaced. Apply the lubrication
sparingly (1 or 2 drops) to the inside circumference of the O-ring, with
your finger or swab (O-ring does not need to be removed).
3. Lastly, re-assemble housing assembly, spring first, then the grip
plates one at a time.
NOTICE: Remove any grease, oil or any other foreign material from
grip plates before use.
Inspect the cutters for damage or dullness. Dull or chipped cutters must
be replaced.
Cutter edges are very sharp. Avoid injury by
avoiding direct contact with the cutter.
TX05249-02-28-17
Mark Insertion
Depth
CD0
200
3-0
2-
28-17
CD0
200
4-
02
-2
8-17
CD019
92
-0
2-
28-17