McElroy 1LC, Руководство оператора

Страница: 17 / 26

Fusing the Pipe
After the heating cycle is completed, open the carriage and
remove the heater and quickly apply fusion force with the lever
handle in accordance with the pipe manufacturer's recommended
fusion procedure or appropriate joining standard. Hold this force
for at least 10 seconds.
After 10 seconds, unlatch the locking cam to assist in holding jaw
position during the cooling cycle.
NOTICE: Failure to follow pipe manufacturer's heating time,
pressure and cooling time may result in a bad joint.
TX04134-05-09-17
Operation
3 - 4
CD0
20
43-0
5-0
8-17
CD0
20
52
-0
5-0
8-17
CD0
20
53-0
5-0
8-17
Inserting Heater
Heater is not explosion proof. Operation of
heater in an explosive atmosphere without
necessary safety precautions will result in serious
injury or death.
If operating in an explosive atmosphere, heater should be brought up to
temperature in a safe environment, then unplugged before entering
the explosive atmosphere for fusion.
Use a clean non-synthetic cloth to clean the butt fusion heater
surfaces.
Verify heater temperature by noting the reading on the dial
thermometer.
Depress the lock on the lever handle and rotate the lever handle
clockwise until it latches.
Insert heater between the pipe ends. Bring the pipe ends against
the heater faces using the pipe manufacturer’s time, temperature
and pressure recommendations or appropriate joining standard for
the heating cycle.
TX04115-8-28-14
CD0
20
51-0
5-0
8-17
¡PELIGRO!
CD0
20
46
-0
5-0
8-17
CD0
20
47
-0
5-0
8-17