McCulloch 32CC TRIMMER, Руководство по обслуживанию, Страница: 7 / 18

McCulloch 32cc Trimmer
5
3.5. Disconnect the throttle cable from the carburetor
by unhooking the Z-fitting at the carburetor end
of the cable. See Figure 3.5.
3.6. After the powerhead is separated from the
boom, and the throttle cable is slackened, the
housing that contains the stop switch and throttle
trigger can be separated from the grip.
NOTE: Alternatively, instead of removing the
complete powerhead and grip from the boom,
the clutch housing can be separated from the
starter housing. If this approach is taken, the
stop switch wires must be disconnected as the
two sections are separated. The throttle cable
will pull out of the starter housing and clutch
housing as the powerhead is removed. Because
of the difficulty of routing the throttle cable back
through the housings, a wire or string should be
connected to the z-fitting so that the throttle
cable can be “fished” back into place.
Figure 3.5
Z-fitting on end of
throttle cable
Throttle arm
on carburetor
3.7. Remove the two screws from the trigger housing
cover using a T-15 driver. See Figure 3.7.
3.8. Push the front part of the housing forward to
remove it. See Figure 3.8.
3.9. The throttle trigger will be released from its pivot
point, and the stop switch will remain with the
rear portion of the housing.
NOTE: The stop switch contacts two rub strips to
ground-out the ignition module. One rub strip is
connected to the primary windings of the mod-
ule, the other leads to ground.
Figure 3.7
Trigger housing
Trigger housing cover
Stop switch
Trigger housing
cover screws
Figure 3.8
Grip
slips out of grip
Trigger housing
Stop switch mounted
on cover plate
Stop switch
contacts