Installation and use
SOLID CONTROL MCK 2000
12
3.2 How to install the sensors
The
SOLID CONTROL MCK 2000
can be equipped with 3 types of sensors:
Inductive sensor for detecting the feed-rate code 481 (always present);
Inductive sensor for detecting the speed of the PTO code 481 (always
present);
grain level sensor code 1403 (optional).
3.2.1 How to install the inductive speed sensor D.18 item 481
The inductive sensor can be installed wherever a mechanical motion exists, on the
(front or rear) wheel of the agricultural machine/vehicle or otherwise creating a
protruding piece of metal for reference, long at least 7 mm (Picture 5
–
ref. <
C
>). We
recommend installing the speed sensor inside the wheel and placing the sensor head
opposite the rim bolts (Picture 5
–
ref. <
A
>).
Set the gap between the sensor and the bolts at about 2/3 mm (Picture 5
–
ref. <
B
>).
Firmly fix the sensor support (supplied) to a secure part of the machine. Fasten the
sensor to the bracket using the nut and the lock nut.
!
Warning
The sensor cable should be covered with a rubber sheath.
Picture 5. How to install the speed sensor.
Inner side of wheel
Speed sensor
Metal reference
