Installation and use
17
MCK 3000
5. Setting the work parameters
5.1 Setting the working width
Set the total working width
“M”
by turning the instrument on (
key) and pressing
the
key several times until the first arrow on the left on the display lights up.
Settable range
:
0.10
40.00
step
:
0.01
default
: 5.00
Press
and
to change the parameter.
Once the desired value has been reached, release the keys and wait <3> seconds to
allow the new parameter that has just been entered to be saved.
5.2 Setting the calibration of the feed-rate
Set the calibration of the feed-rate
“C”
(number of pulses coming from the speed
sensor every 100 metres covered by the machine), by turning the instrument on
(
key) and pressing the
key several times until the second arrow on the
left on the display lights up.
Settable range
: 50
999
step
: 1
default
: 200
Press
and
to change the parameter.
Once the desired value has been reached, release the keys and wait <3> seconds to
allow the new parameter that has just been entered to be saved.
N.B.
it is recommended to calibrate this parameter automatically (see paragraph
, “Automatic calibration of parameter C””).
