MCK 3000
Installation and use
MCK 3000
3.2.1.1
Automatic calibration of the “C” parameter
Parameter “C” is automatically set by covering a fixed distance of 100 metres,
according to the following procedure:
▪
With the Monitor on, press the
key several times until the arrow on the
display lights up as shown in the figure:
;
▪
press keys
and
simultaneously: 0 0 will appear on the Monitor;
•
cover 100 metres and the display will show the pulse count (1..2..3, etc.); once
the 100 metres are covered, confirm with the
key
.
N.B.:
it is recommended to perform the operation at least 2 times in a row, checking
that the detected value is always the same
1 pulse. If the difference is
greater, it means that the speed sensor is NOT positioned correctly.
Therefore, the assembly must be checked (see Figure 4)
