MBW 973-SF6, Руководство по эксплуатации

Страница: 41 / 49

MBW973-SF6_MANUAL_E_V3.1
37
Selection of Units
The data may be viewed in any of the many available units.
Use the lower right menu key to select the Units menu.
Units appears on the key and the keys above show the
various units. Note that each of the keys shows different
types of units. Unlike the
Parameter menu, the keys do not
correspond to the data lines, but rather to different unit
types.
To change temperature units, press the key labeled Temp .
Note that the corresponding unit changes each time the key
is pressed. Also note that any data line that is currently in-
dicating temperature data also changes to the new unit.
Change other units such as Pressure , Flow Rate , etc. with
the same method.
In addition to setting the Pressure units, the mode may be
set to either absolute or relative mode.
Note: Relative mode is often referred to as ‘gauge mode’ or
‘over-pressure’.
If you like, you may clear the menu keys when finished by
cycling through all the menus using the lower right key on
the touch screen, or by pressing the
Enter key once. Note
that this is not required and nothing is wrong with leaving
the
Units menu (or any other menu) on the screen.
Note:
The changed units remain displayed as long as the instru-
ment is in operation. After restart of the instrument, the dis-
play is set back to the standard configuration. Both the
units of the instrument and those of the Excel Protocol are
independent of each other and must separately be
selected.