MBRP Off Camber Fabrications 130717, Сборка

Страница: 3 / 4

4. Lift the
Driver Side Assembly into position on the side of
the hardtop. Line up the holes and slide the 5/16”x1”
Button Head Screws through the hard top, through the
holes in the Inner Brackets , and secure using the supplied
5/16” Nyloc nuts . Do not fully tighten the bolts yet. You will
need 2 people for this step. Refer to Figures 3 and 4.
5. Install the
Front and Rear Crossmembers by sliding the
ends of the Crossmembers into the ends of the Driver Side
Assembly . Ensure the accessory mounting pads are facing
up, the light wiring holes are facing rearward on the Front
Crossmember , forward on the Rear Crossmember , and the
bolt holes in the Crossmember line up with the holes in the
Driver Side Assembly . Secure the Crossmember by
inserting the supplied 5/16”x2.5” Button Head Screws ,
5/16” Nyloc Nuts and Washers . No washers are required
under the head of the screws. Do not tighten yet. Refer to
Figures 6 and 7.
130717 9/09 Page 3 of 4
Figure 3
Figure 4
Figure 6
Figure 7