5
- Turn the pressure control knob clockwise approximately
1/3 of the way down to increase pressure until the sprayer
cycles evenly and solvent flows freely from the bleed hose.
- Allow the sprayer to run for 15-30 seconds to flush the
test fluid out through the bleed hose and into the waste
container.
- Turn off the unit
a) To turn off the gas engine
PAINTING
Set the pressure to minimum by turnig the
pressure control knob fully conterclockwise.
Move the throttle lever to the slow position.
Turn the engine switch to the OFF position.
b) To turn off the electric motor.
Set the pressure to minimum by turnig the
pressure control knob fully counterclockwise.
Move the ON/OFF switch to the OFF
position.
NOTE: Make sure that the spray gun does not have a
tip or tip guard installed.
- Close the bleed valve by turning it fully clockwise.
- Start the engine or turn on the electric motor.
- Turn the pressure control knob clockwise approximately
1/3 of the way down to increase pressure.
- Unlock the gun by turning the gun trigger lock to the
unlocked position.
- Trigger the gun into the metal waste container until the old
solvent is gone and fresh solvent is coming out of the gun.
- Lock the gun by turning the gun trigger lock to the locked
position.
- Set down the gun and increase the pressure by turning the
pressure control knob slowly clockwise.
- Check the entire system for leaks. If leaks occur, follow
the ‘’Pressure Relief Procedure’’ in this manual before
tightening any fitting or hoses.
- Follow the ‘’Pressure Relief Procedure’’ in this manual
before changing from solvent to paint.
W A R N I N G
Be sure to follow the pressure relief procedure
when shutting the unit down for any purpose,
including servicing or adjusting any part of the spray
system, changing or cleaning spray tips, or preparing
for cleanup.
- Place the suction pipe into a container of paint.
- Place the bleed hose into a metal waste container.
- Set the pressure to minimum by turnig the pressure control
knob fully counterclockwise.
- Open the hydraulic shut-off valve located on the hydraulic
pressure hose. The handle should be in line with the hose.
- Open the bleed valve by turnig it fully counterclockwise.
- Start the engine or turn on the electric motor.
a) To start the gas engine.
Move the fuel valve lever to the open position
Move the throttle lever to its middle point
Move the choke lever to the closed position for a
cold engine or to the open position for a warm
engine
Turn the engine switch to the ON position
Pull the starter rope briskly until the engine starts.
b) To start the electric motor, move the ON/OFf switch
to the ON position
- Turn the pressure control knob clockwise approximately
1/3 of the way down to increase pressure until the sprayer
cycles evenly and paint flows freely from the bleed hose.
- Turn off the unit
a) To turn off the gas engine.
Set the pressure to minimum by turnig the
pressure control knob fully conterclockwise.
Move the throttle lever to the slow position.
Turn the engine switch to the OFF position.
b) To turn off the electric motor.
Set the pressure to minimum by turnig the
pressure control knob fully counterclockwise.
Move the ON/OFF switch to the OFF position.
- Remove the bleed hose from the waste container and
place it into the container of paint.
- Close the bleed valve by turning it fully clockwise.
- Start the engine or turn on the electric motor.
- Turn the pressure control knob clockwise approximately
1/3 of the way down to increase pressure.
- Unlock the gun by turning the gun trigger lock to the
unlocked position.
