4
•
Warning – personal danger!
¾
Increased risk with safety installations switched off. Basically do not disassemble
or switch off safety installations.
¾
Check for correct functioning of the safety installations on a daily basis.
¾
Report faults and defective safety installations to the manufacturer immediately.
¾
Keep casing closed during operation and only open once the malfunction is
eliminated.
¾
Only carry out repair on the compressed air supply lines and their components in
a depressurised condition.
¾
In using chemicals please observe the relevant safety data sheets and notes for
disposal, supplied by the respective manufacturer. Also take into consideration
the local safety requirements.
¾
Press the “emergency switch inside the line” for maintenance and repair works.
Also, the machine must be “switched off”.
¾
Close off the “danger zone” accordingly for maintenance and repair works (by
means of the appropriate danger notices and warning notes).
¾
Stop the “system (line)” and press the “emergency switch inside the line” before
you reach into the machine. This will avoid any possible danger to life and limb.
¾
In “threading” the paper, observe the safety instructions, as there is a particularly
high risk of injury from the slitter motor, guide rollers, spindles, antistatic unit etc.
for the operator.
Warning:
•
An element of risk also remains for man and machine, if the Split & Merge Station
is installed incorrectly or not operated as intended. Because the machine
performs “rotating, pivoting as well as mechanical and electrical” work!
•
Also, by adhering to the functionality described in this instruction manual, there
remains an element of risk by e.g. ripping the paper web during production. The
operator could be injured by e.g. the rotating splitter motor, the powered antistatic
unit etc. Should the paper web tear, the machine (line) must be stopped
immediately, by pressing the switch "STOP (16) on
MBO
sheeter” or
the “set
up switch (1) on the
MBO
unwind”. Furthermore, it is
recommended that
you press the emergency switch in the event of “malfunction”.
•
There is an element risk for the operator if the machine is handled incorrectly, e.g.
turning of the "pneumatic draw rollers", the side and height registering, splitter etc.
There is a danger of the operator being cut or crushed/trapped. You therefore
operate the machine, as described under point 6.1.
•
If it is necessary to disassemble safety installations for set-up, repair and
maintenance work, then all installations are to be refitted afterwards.
•
The machine may not be operated in areas where there is risk of explosion, such
as e.g. explosive dust. Any usage beyond this is not regarded as conventional.
The manufacturer takes no responsibility for any resulting damages. The
user/operator bears the risk alone.
•
No liability will be assumed for damages and machine breakdown, which results
from:
¾
Disregard of instruction manual
¾
Machine modifications on one's authority.
¾
Handling faults.
¾
Improper work on and with the equipment
¾
Use of inadequately skilled employees.